xRESIN® Model V01 - 385-405nm (water wash / beige)
xRESIN® V01 - Model Water-Wash / 385nm and 405nm (1000g).
Color: beige-opaque.
Compatible with the xPRINT System and all open - 3D printers.
Individual parameters on request.
Washable 3D Resin Specification:
- Low odor nuisance
- Water washable
- Very good resolution
- Made in Germany
Waser Washable Resin for LCD Modeling (Photopolymers - Synthetic Resin) is optimized for the low light of LCD displays. The efficiency is much higher than comparable resins on the market. The resin is recommended for LCD displays. It is also compatible with DLP or SLA printers.
Resin parameters:
- 385 to 405 nm wavelength
- Shore Hardness (D): 84
- Viscosity (25°C): 200 MPa/s
- Liquid density: 1.20/cm³
- Bending strength: 58 Mpa
- Extensibility: 36Mpa
- Elongation fracture: 8.00%
- Young modulus : 2200 Mpa
- Shelf life: 18 months
Print Settings:
- Exposure time of the ground layers (4-12 layers) in seconds: 25-40s
- Exposure time of the model layers in seconds: 0.8-6s
Storage method:
Protect from light and store at room temperature. (Sunshine may harden the photosensitive resin.) It is recommended to store the resin at an ambient temperature of 15 to 35 °C. The lower the temperature, the higher the viscosity of the resin. Sealed storage, excessive dust or moisture can affect print quality.
Usage:
Shake well before use. Avoid using resin in places with a lot of sunlight. DO NOT rinse printed objects under the tap Please ensure these chemicals are not released into the environment Use tubs/containers filled with water Pour unused resin back into the original resin bottle. Also, avoid leaving the resin in the tub for too long without use, as any resin contamination could affect a future print (without having poured the resin into airtight containers or sealed it with plastic wrap).
Post-processing:
Remove the model via the metal scraper and clean the model in the cleaning box with water to wash off the excess resins in less than 2 to 3 minutes. Then put the model in another cleaning box and clean it with water to wash off the excess resins in less than 2 to 3 min. The model is finally cleaned in a water-filled ultrasonic device in less than 1 to 2 minutes. After cleaning, dry the model with a dust-free cloth or an air gun. Possibly to harden the model in a hardening box at 35°C.
Compatible:
xPRINT and all open printers
Manufacturer: xDEPOT
Data sheets:
xRESIN safety data sheet (PDF)
xRESIN Instructions for Use (PDF)
Datenblatt
- Produkttyp
- Chargen